11/4/2023 0 Comments Kali wireshark monitor mode![]() * 5700 MHz (20.0 dBm) (no IR, radar detection) ![]() * 5680 MHz (20.0 dBm) (no IR, radar detection) * 5660 MHz (20.0 dBm) (no IR, radar detection) ![]() * 5640 MHz (20.0 dBm) (no IR, radar detection) * 5620 MHz (20.0 dBm) (no IR, radar detection) * 5600 MHz (20.0 dBm) (no IR, radar detection) * 5580 MHz (20.0 dBm) (no IR, radar detection) * 5560 MHz (20.0 dBm) (no IR, radar detection) * 5540 MHz (20.0 dBm) (no IR, radar detection) * 5520 MHz (20.0 dBm) (no IR, radar detection) * 5500 MHz (20.0 dBm) (no IR, radar detection) * 5320 MHz (20.0 dBm) (no IR, radar detection) * 5300 MHz (20.0 dBm) (no IR, radar detection) * 5280 MHz (20.0 dBm) (no IR, radar detection) * 5260 MHz (20.0 dBm) (no IR, radar detection) The first step it to determine what channels your setup supports with the following: netbeez$ iw list The driver and hardware support the requested channel and width values.In my case, it was on channel 149 at 80MHz: netbeez$ iw wlan0 infoĬhannel 149 (5745 MHz), width: 80 MHz, center1: 5775 MHzĪs always, when setting a channel and channel width we have to make sure that Once you set the interface to monitor mode the channel and channel width are left at the same configuration they were while the interface was connected to your WiFi network (if it was ever). The syntax of settings channels has changed after version 4.14, and in order to get the correct syntax you can enter an incomplete command to get the help output as follows: netbeez$ iw dev wlan0 set channel In my case, I have installed version 5.9: iw -version In order to be able to set 80 MHz channels with iw, you need version 4.14 or greater. In this post, we’ll talk about how to set the channel and the channel width on a monitor interface but also now to do channel hopping while running a packet capture.įor the purposes of this post I use the same setup with the previous post in terms of hardware, WiFi dongle, driver and iw version. In a previous post we talked about how to set a WiFi interface to monitor mode manually, but also through a script.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |